19981
General Mach Discussion / Re: X axis will not change direction during cut
« on: February 28, 2009, 04:49:14 PM »
I have no idea why it would work fine from MDI and Jogging but not when running code, only thing I can think of is it is due to both axis running at the same time, see if you can command a move via MDI for X and Y such as G1X10Y10F10 and then while it is moving MDI G1X0Y0F10 and see if it reverses on both axis at the end of the first move.
If you want also attach your xml for the profile you are using and I will have a look and see if I can find a problem there, you will find it in the Mach3 folder and will be the name of your profile, eg if you use the standard Mach3Mill profile it will be called Mach3Mill.xml. You will need to rename it for the forum to accept so copy it to your desktop and rename to Bryan.xml then attach using the additional options button on the reply page.
Hood
If you want also attach your xml for the profile you are using and I will have a look and see if I can find a problem there, you will find it in the Mach3 folder and will be the name of your profile, eg if you use the standard Mach3Mill profile it will be called Mach3Mill.xml. You will need to rename it for the forum to accept so copy it to your desktop and rename to Bryan.xml then attach using the additional options button on the reply page.
Hood