54
« on: September 08, 2011, 11:56:13 AM »
I have a Laguna Smartshop router (Industry Controls MCB-1 controller/Mach3/4 with stepper motors) and am trying to find a common ground between exact stop and constant velocity. The see the stop at angle setting and it is at 90, but that doesn't seem to do anything because I'm still left with 1/2 radius corners on 2x2 parts cuttings at 300ipm.
I use cabinet vision and aspire, cabinet vision files are almost always longer segments and arcs, but aspire turns many moves into small incremental moves and in exact stop the machine crawls and vibrates through these parts of the code. I though this might be able to be handled in the post, switching between G61 and G64 depending on the distance between points, but I'm not sure that's possible. Any advice would be appreciated.