691
Mach4 General Discussion / Re: controlling JP-3163B in 6040T USB CNC with Mach4
« on: December 27, 2017, 01:05:54 PM »
Yeah, you can use any stepper drives that you want.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I DID BUY A BOARD FROM THE US. IT CAME FROM OPENBUILD,
DENNIS
The 400ETH has two ports. It is pretty much mandatory that pins 2-9 of port 1 are outputs, for your motors. However you can with port 2 change pins
2-9 from outputs to inputs. Note you can assign them as inputs OR outputs, not half and half.