761
Share Your GCode / Re: Multi pass facing program
« on: April 03, 2012, 06:34:30 PM »
Thanks, nice to see a lathe routine. one of these days I will get my lathe build done and put your routine to use.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
O001
#100=-0.05(X Initial Home Start Point)
#101=-0.01(Y Initial Home Start Point)
#102=0.0 (Z Start Point)
#104=5.0 (X End Point)
#105=25 (Depth of Cut 25 *.002" = .05")
#106=15 (Number of Passes 15 * .02" *.02"= .6")
#107=0.002(Depth of Z cut)
#108=0.02 (Step over Y amount)
M3(Grinder Started)
G90
G0 Z0.1
X#100 Y#101(Go to the Initial Start Point)
Z#102
M98 P10 L#105
M5
M30
O10
#100=-0.01(X resets Home Start Point)
#101=0 (Y resets Home Start Point)
#102=0 (Z resets Home Start Point)
G0 X#100 Y#101
#102=[#102-#107]
G0 Z#102
M98 P20 L#106
M99
O20
#101=[#101-#108]
G1 Y#101 F90
X#104
#101=[#101-#108]
Y#101
X#100
M99
(Put comment here to make sure I have a carrage return on the last M99)
O01
#100=-0.05(X Initial Home Start Point)
#101=-0.01(Y Initial Home Start Point)
#102=0.0 (Z Start Point)
#104=5.0 (X End Point)
#105=25 (Depth of Cut 25 *.002" = .05")
#106=15 (Number of Passes 15 * .02" *.02"= .6")
#107=0.002(Depth of Z cut)
#108=0.02 (Step over Y amount)
M3(Grinder Started)
G90
G0 Z0.1
X#100 Y#101(Go to the Initial Start Point)
Z#102
M98 P10 L#105
M5
M30
O10
#100=-0.01(X resets Home Start Point)
#101=0 (Y resets Home Start Point)
#102=0
G0 X#100 Y#101
#102=[#102-#107]
G0 Z#102
M98 P20 L#106
M99
O20
#101=[#101-#108]
G1 Y#101 F90
X#104
#101=[#101-#108]
Y#101
X#100
M99
(Put comment here to make sure I have a carriage return on the last M99)