Oh, great on the 5V, as the encoder works.
I wont worry about it then.
Yes, I have the spindle setup in the plugin.
The spindle works perfectly re: fwd and back .. its just that I dont get an rpm readout.
In encoder module, the position and angle change between position o, angle 0.0 and position -1/angle 360.
I remember that threading needs the RPM readout to work.
Do you know if the ENC is on another port and thats the signal I should feed to mach for the index signal ?
Or is it that the ENC based threading may work even if the RPM readout does not.
ENC fw is 1.02
MPG fw is 1.10
CSMIO fw is 2.500 / FPGA 2.50 (October 24/2014).