Thanks for your comments
There are a few thing that would need changes before I can share the SWF
1) The ref button runs a routine to square my routers gantry. I have to change it to an external macro so anyone can replace it for their own
2) My router does not have auto tool changer.
I have all my tool information entered into my cam. I dont want to keep it duplicated and synchronized in mach. So I changed my cams postprocessor to make it send tool information to mach. This way each time a new tool is needed a flash popup appears that shows a picture of the tool with its requested parameters such as material, diam, outside holder length, etc.
3) For the auto tool zero, the plate location is currently hard coded to my machines position
About the nesting and writing wizzards (billman311)
Both would be very nice, specially the nesting one, I use it all the time.
I would need to learn some more about opening and processing dxf files (or maybe I can nest directly NC programs by rotating and offseting them)
I will add it to my wishlist
Thanks for your comments
Pablo