3101
VB and the development of wizards / Re: Use touchscreen to manual jog machine
« on: January 18, 2017, 02:13:01 AM »
Which version of Windows are you using ?
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi.well I have reset the estop. I have the leds showing ok for the smooth stepper.HG08 BOB and on the motor driver.I
I have 5v at the BOB at the VCC pin but this go's down. to 2.69v on the, other output pins.there is no sign of voltage movement at the pins during jogging in Mach 3 and the motor does not turn
Does Mach inherently shut the spindle down at the end of the g-code and what triggers it??