1711
General Mach Discussion / Re: Guidence Request... Surface probing with Mach3 & a Gecko G540.
« on: May 07, 2018, 02:39:15 PM »
well. digitizing is a very "hot" Point.
you are talking about "accurate model ".
what do you define with "accurate" ??!
let's say you have a door Panel 200x100 cm, and you what to have a probing every 1mm,
ok that Needs 2000000 Points (in word's two million's).
i hope to give you a idea what accurate means, because every modelling Software is "living"
from data.
3d scanning is your friend, if you what do do this, but this is an other $$ diamention, as we are talking about.
sorry that i have "destroyed" your idea.
Thomas
you are talking about "accurate model ".
what do you define with "accurate" ??!
let's say you have a door Panel 200x100 cm, and you what to have a probing every 1mm,
ok that Needs 2000000 Points (in word's two million's).
i hope to give you a idea what accurate means, because every modelling Software is "living"
from data.
3d scanning is your friend, if you what do do this, but this is an other $$ diamention, as we are talking about.
sorry that i have "destroyed" your idea.
Thomas