5701
General Mach Discussion / Re: Setup Of New Breakout Board
« on: October 20, 2012, 02:03:12 AM »
Check that you have the correct configuration of Ports and Pins in Motor Outputs for your Y Axis.
Unplug your X Axis motor and try it in the Y Axis output.
If you still have no response from your Y Axis then I would suspect that the driver chip for that axis is damaged.
Tweakie.
Unplug your X Axis motor and try it in the Y Axis output.
If you still have no response from your Y Axis then I would suspect that the driver chip for that axis is damaged.
Tweakie.