Guest
Show Posts
1
General Mach Discussion / Probe Problem after controller change
« on: September 02, 2023, 05:02:34 AM »
Good day to you all,
I use Mach3 with Manfred Schmidt's screen and until recently I had a UC100 controller (USB to parallel). Since the controller was now defective, I have now bought a UC400 (ETH to parallel). Now I have the problem that when I use the tool length sensor and the contact closes, the following error appears: "Probe ignore, activated at call for probe" appears, and "Probe" also flashes in the small window.
Otherwise everything seems to be working, can anyone help with this?
Thank you very much,
Wolfgang
I use Mach3 with Manfred Schmidt's screen and until recently I had a UC100 controller (USB to parallel). Since the controller was now defective, I have now bought a UC400 (ETH to parallel). Now I have the problem that when I use the tool length sensor and the contact closes, the following error appears: "Probe ignore, activated at call for probe" appears, and "Probe" also flashes in the small window.
Otherwise everything seems to be working, can anyone help with this?
Thank you very much,
Wolfgang