1181
CS-Lab / Re: CSMIO-ENC Spindle Orientation
« on: January 17, 2016, 05:43:29 AM »
Never tried it on the Chiron which is the machine with the IP-A as I do not need to orient the spindle for tool changes.
I did use it on the wee lathe to stop the spindle at the correct position for the chuck key and it worked well. The wee lathe however had an IP-S.
All I had to do was enter a value in the angle box and enable the option, no macro required.
If I get a chance and more importantly remember I will test it out on the Chiron when I get back to the workshop tomorrow.
Hood
I did use it on the wee lathe to stop the spindle at the correct position for the chuck key and it worked well. The wee lathe however had an IP-S.
All I had to do was enter a value in the angle box and enable the option, no macro required.
If I get a chance and more importantly remember I will test it out on the Chiron when I get back to the workshop tomorrow.
Hood