21
Mach4 General Discussion / Mach 4 macro for setting current fixture offset to zero?
« on: April 30, 2018, 10:45:13 AM »
I'm making a macro for probing the work piece. I put a probe block on the work piece or table top, and lowers the spindle until getting contact with the block. When contact I want to set the current fixture offset to zero. However I cannot find a way to read out which is the current active offset, and write to this same offsets Z-position.
This could be the same functionality that is in the Zero z button on mach4 mill screen, but I don't fin what is behind that button. Any Ideas on which pound variables to write to or other ways to solve it?
This could be the same functionality that is in the Zero z button on mach4 mill screen, but I don't fin what is behind that button. Any Ideas on which pound variables to write to or other ways to solve it?