6564
« on: February 02, 2009, 06:56:02 PM »
cuecaps,
There are not manny single line fonts out there if memory serves me.
I am guessing, but one of them is called "STICKMAN" and that gives you single line.
( if i fiind it i'll post it here)
Try exploding the font before you DXF it and get rid of the boarder. Just be aware that
you will get lots of little lines. One of the things i used to do is draw over the text using arc's.
That will reduce the Gcode file a lot and it looks so much nicer even at a small scale.
If your machine can't hold good tolerances, well that's another story, just depends on how particular you want
to get.
RICH