3
« on: July 05, 2009, 03:53:27 PM »
I just became a new user. Tried the rectangular wizard. Anyway, ran the G-code file e-stopped it before any problems occurred the first time, changed the soft limits from the default to ones compatible with the X3 table size.
Regenned and ran the file....well the second time I didn't hit e-stop quick enough....the saddle flew past the hardware limit switch as if it wasn't there!
I found all the ball bearing from the y-axis and I'm trying to fix that.
I do have the auto-override set, and it works when I reference all. I have noticed something pecuilar...after it references it goes into a e-stop.
Did my limit switch bounce and is that what caused the problem?
I would hate to fix the ballnut and have it happen again.
Thanks,
Paul