581
General Mach Discussion / Re: Machine setup help - urgent if possible :)
« on: July 23, 2016, 10:02:55 AM »
Never done the Stop Spindle option with IP-A so not sure if it is that or Mach that is your issue.
One thing it may be with the stop spindle option is, the M6End is used with that option, so edit out all the crap in it and see if it helps.
Failing that you could possibly use the auto change option and have something like the following in the M6Start
Code "M5"
Code "G53 G0 Z-5"
While IsMoving()
Wend
Hood
One thing it may be with the stop spindle option is, the M6End is used with that option, so edit out all the crap in it and see if it helps.
Failing that you could possibly use the auto change option and have something like the following in the M6Start
Code "M5"
Code "G53 G0 Z-5"
While IsMoving()
Wend
Hood