11173
« on: July 22, 2011, 03:14:13 PM »
The table view is set by your soft limits settings so set them up from Config Menu, Homing and Limits.
Assuming a conventional machine setup....
The X and Y Min will be zero
The Z Max will be Zero
The X and Y Max will be the travel of each axis
The Z Min will be the travel of the Z in a negative value.
You will really need Home switches for this or you will have to move to the X and Y fully negative and Z fully positive and then press RefAll if you dont have Home switches.
The reason you need to Home is so that Mach knows where it is in relation to your axis positions.
Hood