Messages

4111

General Mach Discussion / Re: spindle and charge pump

« on: July 15, 2008, 12:49:15 PM »

Thanks for responding.....I'm in the "Basic" boat as well.
I can pretty well interpret what I read....depending on how it's written.
Here is an example of what blows my mind. 

The second statement is apparently wrong.

Don't hesitate to post your questions...if you get another board. I might have this figured out by then and would be happy to help.
Thanks again Wil,
RC

4112

Promote and discuss your product / Re: New Wizards for Indexers

« on: July 15, 2008, 11:43:41 AM »

Sounds GREAT...
Would like to see an example/screenshots.
RC

4113

General Mach Discussion / Re: Charge Pump Output Check/Verify ?

« on: July 15, 2008, 11:39:49 AM »

I checked as well....1.97v
Thanks Hood,
RC

4114

General Mach Discussion / Charge Pump Output Check/Verify ?

« on: July 15, 2008, 10:23:38 AM »

Hey Folks,
Using a DMM, can the Mach Charge Pump freq. be checked... or just verified on its assigned port/output pin ?
Not the actual pulse count, just positive evidence of its presence.
Thanks,
RC

4115

General Mach Discussion / Re: spindle and charge pump

« on: July 15, 2008, 08:59:57 AM »

Hello Wil,
Did you ever get this resolved ?
Just wondering....I'm having similar problems.
I sent you a PM also.
Thanks,
RC

4116

General Mach Discussion / Re: Output Pin Problem

« on: July 14, 2008, 05:34:16 PM »

Still having problems here.....Any luck there Matt ?
I'm stuck right now.....waiting for Mr. Duncan.
Keep me posted if you will,
RC

4117

General Mach Discussion / Re: M3Turn Output always ON

« on: July 05, 2008, 07:03:19 PM »

Poppabear,
I think I remember when it may have happened now.....
http://www.machsupport.com/forum/index.php/topic,5806.0.html
I'll put this back in and include the deactivate signal.
Thanks,
RC
 

4118

General Mach Discussion / Re: Setting up a 4th axis?

« on: July 05, 2008, 04:27:35 PM »

That sound good Hood.
Only possible problem that I see is the belt being the weak link in that all of the cutting/tooling pressure during anX axis move will be against the belt instead of the "Metal to Metal" contact in a normal gear arrangement. Maybe use a brake of sorts ?
Should be fine for lighter cuts in softer matl though.
RC

4119

General Mach Discussion / Re: M3Turn Output allways ON

« on: July 05, 2008, 03:41:59 PM »

Thanks for checking.
The only way I found to get rid of it was to do another Turn profile.
No biggie, unexplainable stuff like that just bugs me.
Anxious to see if you can find the culprit though....please keep me posted.
Thanks again,
RC

4120

General Mach Discussion / Re: Setting up a 4th axis?

« on: July 05, 2008, 03:30:05 PM »

http://www.machsupport.com/forum/index.php/topic,6158.0.html
Budman, Here is a neat topic. Gearbox to Axis conv....In case you haven't seen it.
RC