17541
General Mach Discussion / Re: No file/load dxf option, only ENTIB. Whats this?
« on: November 13, 2009, 11:58:25 AM »
That code is not good, lots of lines have no movement as they are telling the machine to go to where it is already, ecxample line 18 to line 41 have all the same move.
The lines such as N4 and N17 are not needed because you have added the F10 in the lines before but really the programme you are using to produce the code should have had lines 3 and 4 the opposite way round and same for 16 and 17.
Looks like your deskengrave is putting out bad code and you will have to mess around with the settings in it, afraid I know nothing of deskengrave so cant be much help
It might be easier for you to look at the text wizard in Mach for simple single line letter engraving.
The lines such as N4 and N17 are not needed because you have added the F10 in the lines before but really the programme you are using to produce the code should have had lines 3 and 4 the opposite way round and same for 16 and 17.
Looks like your deskengrave is putting out bad code and you will have to mess around with the settings in it, afraid I know nothing of deskengrave so cant be much help
It might be easier for you to look at the text wizard in Mach for simple single line letter engraving.