7381
General Mach Discussion / Re: strange behaviour / offset
« on: September 26, 2012, 10:03:33 AM »
Kernel has no effect with external devices, any limiting of frquency is done in the plugin.
Could be your Z is losing steps due to the short fast moves that 3D usually contains.
Have you tried reducing the acceleration for the Z axis?
Do you have the step pulse set to the correct state for your drives? ie active high or active low as some drives are particular about that.
Hood
Could be your Z is losing steps due to the short fast moves that 3D usually contains.
Have you tried reducing the acceleration for the Z axis?
Do you have the step pulse set to the correct state for your drives? ie active high or active low as some drives are particular about that.
Hood