10671
General Mach Discussion / Re: Windows & and smooth stepper missing steps
« on: September 14, 2011, 02:11:13 PM »
Did the toolpath show the tool to be on position with the code or did it show it higher?
Is it possible the code was telling the cutter to go there?
Could your cutter have been pushed into the collet?
Could your axis have stalled as it was plunging into the material?
Hood
Is it possible the code was telling the cutter to go there?
Could your cutter have been pushed into the collet?
Could your axis have stalled as it was plunging into the material?
Hood