3456
« on: November 27, 2018, 05:07:46 PM »
Hi,
I have a VistaCNC P1A and it works well, I struggled a bit at the beginning but its OK now.
The VistaCNC Mach4 plugin is a bit cranky. You are correct, it does not have a configuration screen.
VistaCNC is the only pendant manufacturer, to my knowledge, that have produced a Mach4 plugin, so while
the plugin may be buggy they deserve thanks for making the investment in time an resources to do it.
It seems, yours is not the first post, that its the screen on the pendant that causes the issue. My pendant does not have
one and it works fine, in fact anyone who has a screen-less VistaCNC pendant is OK.
I would suggest you contact VistaCNC.
It may be possible to disable the screen and therefore avoid the buggy bit of code.
There have been several threads about this but without the forum search function its very time consuming trying to fin them.
Craig