3611
General Mach Discussion / Re: Z axis moves down after program ends
« on: December 14, 2013, 10:17:05 AM »
Regarding the "big looping motion", that is most likely the IJ mode is wrong. To solve that the best option is to have the post processor in BobCAD put the correct G90.1 or g91.1 in the initialisation string. You can also change the default setting in General Config of Mach or simply MDI it, however if you load code written for the opposite IJ mode and the code doesnt define which (by having a G90.1 or G91.1) then it will again be wrong and you will have to MDI or change the setting again.
Egg shaped cicles sounds like Backlash and is nothing to do with Mach.
Hood
Egg shaped cicles sounds like Backlash and is nothing to do with Mach.
Hood