7071
General Mach Discussion / Re: Allen Bradely drives to Sanyo denki motors ?
« on: October 20, 2012, 07:19:45 PM »
Ok its pin 4 and 12, one needs to be connected. Pin 4 to Vcc or pin 12 to Gnd.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Where is 0,0 dumb question I know.
Rapids are extremely fast which are nice but not necessary. Cant figure out why they wont change with ipm .Rapids are set in Motor tuning so whatever you have as Velocity there is what the rapids will be, unless you have the rapid override turned down, then they will be whatever % you have that set to of the full rapid speed.
Another issue is tool post position . Id like the code from the wizards to set tool post position in front, closest to operator. I do not intend on using rear post any time soon. X start and x end seem to be very different from one wizard to another this is where i get very confused. Does this have anything to do with dia. mode. I am in diameter mode which i am also unsure of. I normally dont write my own codes but rely on cad/cam software, wizards and nfs in mill and would very much like the same aspects with turning. If I posted my xml file will this be helpful. Any help would be great.You can set the tool to show above or below centreline but that is just a visual thing. The important thing is that as you move your X towards the centre line of the lathe the X value decreases and as you move away it increases. If yours is not that way then you need to reverse the Directions active state for that axis. In the wizards it doesnt matter whether you are in Dia or Rad mode as the code in the wizard should look to see which mode you are in and write the G-code accordingly.