I wanted to ask the Mach3 forum about a specific plasma issue which might be related to the feeds and speeds I use. Its one of those process of elimination issues, mechanical or software? I'm not getting smooth curves on the cuts and this could one of several issues but i've wanted to discuss my Velocity and acceleration speeds for a while incase these were unusual.
I use T5 belt drive directly from a 15T pulley's, Nema 24 motors and Gecko540.
To cut 3mm (0.125984) plate these are my metric Mach settings
steps: 26
Velocity: 5500mm/min (216.5354")
Acceleration: 100mm/min (3.93701")
Any advice or thoughts welcome
Thanks