7361
General Mach Discussion / Re: Variable speed drive for mill spindle mach3 control
« on: September 27, 2012, 01:27:52 PM »
You can stop/start no problem with just relays to control the VFD but if you want to control spindle speed yo will need a spindle controller as well.
I just recently got one from Peter Homann so I can control an analogue servo for my spindle, it was a breeze to set up and is very linear in its output, definitely a quality product.
Hood
I just recently got one from Peter Homann so I can control an analogue servo for my spindle, it was a breeze to set up and is very linear in its output, definitely a quality product.
Hood