Thanks guys;
Instead of describing the machine, I'll post a picture. It's not an industrial machine, it's one I built.
I made the gantry from aluminum to keep the weight down. Aproximate weight is probably 50Lbs .
I run dual 960in/lb steppers for the Y axis and one for the X.
The Cad/CAM program I'm using is Dolphin Cad. All my electronics are from CandCNC.
Here is the g-code. I changed the speed to 200IPM from the original 350IPM.
You'll notice that the Post Processor did not program radiuses in the corners.
Thanks for having a look.
Dan
N0000 (Filename: Flight box side.tap)
N0010 (Post processor: MP1000-THCdan.scpost)
N0020 (Date: 29/01/2012)
N0030 G20 (Units: Inches)
N0040 G53 G90 G40
N0050 F1
N0060 (Part: Flight box side)
N0070 (Process: Outside Offset, Layer0, T2: .060 ALUMINUM Jet tool)
N0080 M06 T2 F200 (.060 ALUMINUM Jet tool)
N0090 G00 Z0.5000
N0100 X6.2300 Y2.9800
N0110 Z0.1500
N0120 G28.1 Z0.12
N0130 G92 Z0.0
N0140 G00 Z0.0940
N0150 G92 Z0.0
N0160 G00 Z0.1500
N0170 M03
N0180 G01 Z0.0600 F360.0
N0190 X4.2700 F200.0
N0200 Y0.5200
N0210 X6.2300
N0220 Y2.9800
N0230 M05
N0240 G00 Z0.5000
N0250 X10.5000 Y8.2700
N0260 Z0.1500
N0270 G28.1 Z0.12
N0280 G92 Z0.0
N0290 G00 Z0.0940
N0300 G92 Z0.0
N0310 G00 Z0.1500
N0320 M03
N0330 G01 Z0.0600 F360.0
N0340 G02 X10.5200 Y8.2500 I0.0000 J-0.0200 F200.0
N0350 G01 Y0.0000
N0360 G02 X10.5000 Y-0.0200 I-0.0200 J0.0000
N0370 G01 X0.0000
N0380 G02 X-0.0200 Y0.0000 I0.0000 J0.0200
N0390 G01 Y8.2500
N0400 G02 X0.0000 Y8.2700 I0.0200 J0.0000
N0410 G01 X10.5000
N0420 M05
N0430 G00 Z0.5000
N0440 X0.0000 Y0.0000
N0450 M05 M30