4681
Mach4 General Discussion / Re: Mach 4 Bug Reports
« on: July 25, 2014, 08:55:01 AM »
Well, I had to try v.1914 with the Vista Laptop and an IEEE 1284 ‘plug-in’ parallel port. I can’t say I fully trust it with an engraving bit just yet but it seems OK just cutting air.
35 seconds of the test http://www.graytel.talktalk.net/M4b.wmv
There appears to be a slight issue with v.1914 – the A axis responds OK to the MDI command but not from GCode – strange ?.
Tweakie.
35 seconds of the test http://www.graytel.talktalk.net/M4b.wmv
There appears to be a slight issue with v.1914 – the A axis responds OK to the MDI command but not from GCode – strange ?.
Tweakie.