1181
General Mach Discussion / Re: porque usam tanto corrediças de gaveta na posição errada?
« on: December 27, 2019, 01:47:17 AM »
Hi Dantas,
Ideally, posts in this part of the forum should be made in English if you can.
The 'draw slides' make poor linear rails for CNC use. Linear rails which are purpose made for CNC use would be a much better investment in the long term.
Tweakie.
Ideally, posts in this part of the forum should be made in English if you can.
The 'draw slides' make poor linear rails for CNC use. Linear rails which are purpose made for CNC use would be a much better investment in the long term.
Tweakie.