Messages

1

Mach4 General Discussion / Mach4 screen not showing change in X-position

« on: August 04, 2022, 01:20:58 PM »

I am working with a HiCON 7866 and I have the X, Y, and Z motors all configured in a similar manner. I have the Y and Z motors working perfectly, but can't seem to get the X motor to move at all and Mach4 never changes the X position from 0, even after telling it to jog. Any suggestions?

2

HiCON Motion Controller / Re: HiCON Integra 7866 won't connect to Mach4

« on: August 02, 2022, 09:07:11 AM »

Thank you!

3

HiCON Motion Controller / Re: HiCON Integra 7866 won't connect to Mach4

« on: August 01, 2022, 10:07:52 AM »

I have called them and had a couple remote sessions, too, but the person helping me couldn't figure it out. I was hoping maybe a fresh set of eyes would be helpful.

4

HiCON Motion Controller / Re: HiCON Integra 7866 won't connect to Mach4

« on: August 01, 2022, 09:10:08 AM »

Do you know the email of the person that helped you by any chance?

5

HiCON Motion Controller / HiCON Integra 7866 won't connect to Mach4

« on: July 29, 2022, 09:52:23 AM »

I am working with a new HiCON Integra 7866 and I am struggling to get Mach4 to connect with it. When I open VSI Device Manager, it recognizes and finds the HiCON, but when I open Mach4, I get the error message saying "No HiCON Controller Found". I have tried power cycling the HiCON and restarting Mach4 and neither seem to have worked. Has anyone else experienced this and/or have an idea on how to fix it?