1
Third party software and hardware support forums. / Need help -only some signals output on longs breakout board
« on: September 22, 2017, 04:05:49 AM »
I have a home built 3 axis machine with a slave A axis for X travel. It has been working fine with a HY-CLX-S four-axis stepper motor control box.
I decided to upgrade to larger motors and use a Longs breakout board (db25-1205) with 4 drivers. It came as a kit with the motors. I have the new motors installed on the machine and I can't seem to get a signal output on pins 2-9. Only pins 17,16,1,14 seem to work. I have been searching for 3 weeks now and I cant seem to find anyone with the same problem.
For example when I set Y axis to pins 2 and 3 for step and direction I get no movement or signal change. It is a constant 5 V.
If I change it to 17 and 16 for step and direction It works! Any combination of 17,16,1,14. I can assign any of those 4 pins to any one of the 4 axis and I get motion.
But nothing on 2-9! They all read 5 V.
I have changed the breakout board for a new one. Same exact problems. Re-installed Mach3 - no change. I am using an ESS. I purchased a PCI Printer port and couldn't get any communication. I'm running windows 10 so from what I read that wont ever work. So I went back to the ESS.
Any Help would be greatly appreciated. Or does anyone know of any fairly priced remote login services for troubleshooting mach 3 setups?
Thanks
I decided to upgrade to larger motors and use a Longs breakout board (db25-1205) with 4 drivers. It came as a kit with the motors. I have the new motors installed on the machine and I can't seem to get a signal output on pins 2-9. Only pins 17,16,1,14 seem to work. I have been searching for 3 weeks now and I cant seem to find anyone with the same problem.
For example when I set Y axis to pins 2 and 3 for step and direction I get no movement or signal change. It is a constant 5 V.
If I change it to 17 and 16 for step and direction It works! Any combination of 17,16,1,14. I can assign any of those 4 pins to any one of the 4 axis and I get motion.
But nothing on 2-9! They all read 5 V.
I have changed the breakout board for a new one. Same exact problems. Re-installed Mach3 - no change. I am using an ESS. I purchased a PCI Printer port and couldn't get any communication. I'm running windows 10 so from what I read that wont ever work. So I went back to the ESS.
Any Help would be greatly appreciated. Or does anyone know of any fairly priced remote login services for troubleshooting mach 3 setups?
Thanks