18241
General Mach Discussion / Re: Physical Size
« on: August 19, 2009, 05:16:57 PM »
You did read the Mach 3 manual, right?
Dave
Nope afraid I have never done that yet
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
You did read the Mach 3 manual, right?
Dave
You did not mention what kind of spindle motor/controller it is?
Did it previously brake to a stop, or was it just a holding brake?
If it was a holding brake, there must have been some method or signal to indicate zero speed?
Nosmo.
I am not sure what you mean by 'attach your code'. What code?
However, the moment it tries to run g-code I get these predictable stops.