6541
Mach4 General Discussion / Re: Geared AC Servo spinde setup.
« on: September 27, 2017, 01:44:31 PM »
Hi,
I'm not sure either but on the Configure/Mach/Spindle page try setting your minimum, whatever that is, 10 rpm say, your maximum 5000rpm
and the feedback ratio of 3000/5000=0.6. Try it....cant do any harm.
Craig
I'm not sure either but on the Configure/Mach/Spindle page try setting your minimum, whatever that is, 10 rpm say, your maximum 5000rpm
and the feedback ratio of 3000/5000=0.6. Try it....cant do any harm.
Craig