1301
G-Code, CAD, and CAM discussions / Re: sainsmart 3018 MX3 laser does not immediately honour M3/M5
« on: October 05, 2019, 08:26:02 AM »
Hi Lawrence,
Your USB board does not support the use of the M11/M10 command set so it looks like you are back to the beginning.
Your options would seem to be...
Get another (higher spec) motion controller (US or EU origin not Chinese) suitable for use with Mach4.
Try Drufel. Unfortunately this is a low-end controller using HPGL1 for it's image to Gcode conversions but it does have built-in laser routines.
Sorry I can't be of much help with finding a solution.
Tweakie.
Your USB board does not support the use of the M11/M10 command set so it looks like you are back to the beginning.
Your options would seem to be...
Get another (higher spec) motion controller (US or EU origin not Chinese) suitable for use with Mach4.
Try Drufel. Unfortunately this is a low-end controller using HPGL1 for it's image to Gcode conversions but it does have built-in laser routines.
Sorry I can't be of much help with finding a solution.
Tweakie.