1007
« on: May 02, 2012, 08:39:31 AM »
The red high lighted block is the problem area, if you are moving from one fixture to the next you do not need to go back to xyz zero.
N4280 G1 X2.4652 Y.4739 Z-.2216
N4290 X2.4891 Y.4973 Z-.1881
N4300 X2.5125 Y.5212 Z-.2216
N4310 X2.5353 Y.5457 Z-.255
N4320 G3 X2.8941 Y1.475 R1.3827
N4330 G0 Z.5
N4340 M5
N4350 G49 G0 Z0.
N4360 X0. Y0.
N4370 A0.
(--- G55 Work Offset Was Added ---)
G55
%
Just add the fixture offset to the first move line of the second/third fixture code.
N100 G20
N110 G0 G17 G40 G49 G80 G90
( DRILL )
N120 G49 T1 M6
N130 G55 G0 G90 X1.8102 Y1.0638 A0. S5704 M3
N140 G43 H1 Z.5
N150 Z.2