2311
General Mach Discussion / Re: Servo for lathe spindle ?
« on: October 03, 2014, 05:48:46 PM »
Ok what do you have set for the max RPM in your servo drive?
What do you have set for the max Velocity in Motor Tuning in Mach?
Do you have any reduction between motor and screw?
What is the pitch of the screw.
Where have you got the +/-10v output wires connected on the Drive?
Regarding your pics above, it looks like your drives inputs are sourcing only, that is a bit of a pain as the outputs from the CSMIO are also sourcing. That means you would need to use something like a relay if you are wanting to connect outputs from the CSMIO to Inputs on the drive.
You may be able to select to have the drives inputs as Sinking but from the above pic it does not look like it.
Hood
What do you have set for the max Velocity in Motor Tuning in Mach?
Do you have any reduction between motor and screw?
What is the pitch of the screw.
Where have you got the +/-10v output wires connected on the Drive?
Regarding your pics above, it looks like your drives inputs are sourcing only, that is a bit of a pain as the outputs from the CSMIO are also sourcing. That means you would need to use something like a relay if you are wanting to connect outputs from the CSMIO to Inputs on the drive.
You may be able to select to have the drives inputs as Sinking but from the above pic it does not look like it.
Hood