Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: PeteW on September 05, 2006, 08:38:42 AM
-
Hello,
Finally purchased Mach3. Since I am very new to the configuration of Mach3 and the files that affect the way Mach3 runs and is configured I would like to back-up ALL the files that Mach3 uses for my set-up. Since I final have everything working correctly for my Boss5, I don’t want to go through the configuration / set-up again.
A list of all these files would really be great.
Thanks,
Pete W.
-
The .xml file found in the mach folder holds your configuration.
Id suggest backing up the whole mach folder though.
-
The .xml file found in the mach folder holds your configuration.
....
Would this be the only file needed to back-up if I were to change parameters such that
Mach3 will work with a different driver control?
So, I would be able to just make a batch file to rename this file accordingly when using a different driver controls?
-
If you have special M codes and macropump files (which I now you do) you also need your profile folder.
It will be in the Mach 3 directory and have the same name as your *.xml file.
Darek
-
If you have special M codes and macropump files (which I now you do) you also need your profile folder.
It will be in the Mach 3 directory and have the same name as your *.xml file.
Darek
Thanks Darek ... the Uboard is working very well .... and I will not forget to back-up the costume files I got from you.
Pete W.