8851
General Mach Discussion / Re: Machine protection
« on: April 07, 2009, 06:34:45 AM »
Hi,
Two roller blinds, one mounted at each end of the axis with the ends attached to the table, sounds like an extremely good idea to me. Make sure you fit them the right way up so that stuff falls off the ends and does not get rolled up into the blind though.
Tweakie.
Two roller blinds, one mounted at each end of the axis with the ends attached to the table, sounds like an extremely good idea to me. Make sure you fit them the right way up so that stuff falls off the ends and does not get rolled up into the blind though.
Tweakie.