Messages

31

General Mach Discussion / Re: TOOLPATH

« on: May 08, 2016, 05:15:13 AM »

Thank you Gerry
Is it a fault in Mach 3 version 62 then?
I will run the program and see what happens when I do the second side.
Graham

32

General Mach Discussion / TOOLPATH

« on: May 07, 2016, 05:31:04 PM »

Hi all
Version 062 on Win 7
When I load the attached program and look at the program limits on the Toolpath display it displays
x-.125 x+.5347
y-.125  y1.2104
If I then set the scale to x-1 for a mirror image and regenerate the toolpath display I get
x-.5437 y+.125
y-.125  y+1.3365
I can understand the x changing sides but why does the y change as I have not altered that y scale?

Graham

33

General Mach Discussion / Re: Restart prog. in sub prog.

« on: November 04, 2015, 06:29:18 AM »

TP
THANKS for your reply.
Looks like I will be cutting air for a long time!!
Graham

34

General Mach Discussion / Restart prog. in sub prog.

« on: November 03, 2015, 05:11:41 PM »

Hi all
How do you restart a program that you have had to stop, and come out of, from within a sub program loop.
Graham

35

General Mach Discussion / Re: LIMIT SWITCH CABLE

« on: June 20, 2015, 12:22:59 PM »

Thanks Rich and Daniellyall for your help
Was using TV aerial but it is too big and not flexible enough.
Graham

36

General Mach Discussion / Re: LIMIT SWITCH CABLE

« on: June 20, 2015, 04:13:09 AM »

Rich
Is this wire OK
http://www.ebay.co.uk/itm/10m-METRES-SINGLE-CORE-SCREENED-AUDIO-CONNECTION-CABLE-MORE-LENGTHS-AVAILABLE-/131153849167?_trksid=p2054897.l4275

Graham

37

General Mach Discussion / LIMIT SWITCH CABLE

« on: June 19, 2015, 06:49:43 AM »

Hi ALL
What is the best spec fot thin single core screened cable for limit switches, is it Audio??
Graham

38

Finished Plugins for Download / Re: A new Huanyang VFD plugin

« on: June 03, 2015, 12:28:53 PM »

gpz-rider
It is on his website under his questions and replies
Graham

39

General Mach Discussion / Re: Tool Wear Modual

« on: May 31, 2015, 02:20:30 PM »

BRS49
How about grade of tip so you can compare them over usage time?
graham

40

General Mach Discussion / Re: MESH CAM AND TOOL DIA

« on: May 28, 2015, 04:01:15 PM »

GER21
I have run mesh cam before with no problems;
See attached photos of steps I followed.
Graham.
A thought
Will it get to the correct sizes as it gets down to the face of the "OBLONG WITH ROUND ENDS" face which is lower than the top surface as excluded on the left hand side.
Will have to run it through on some plastic too see.
Graham