Messages

1911

LazyCam (Beta) / Re: Pimp my Lcam

« on: December 01, 2006, 09:39:21 AM »

The decimal point code is fixed and we are looking into the drill point problem.

thanks

1912

VB and the development of wizards / Re: Coordinate system rotation

« on: December 01, 2006, 09:28:18 AM »

Yup have that in Mach3 

1913

General Mach Discussion / Re: MACH3 ....017?

« on: December 01, 2006, 09:16:57 AM »

That was Art's bad   Should be okay now (there are a ton of things that you need to do when you do an update)

Thanks
Brian

1914

General Mach Discussion / Re: Sound Logic Encoder Interface anyone?

« on: December 01, 2006, 09:15:09 AM »

I have one here that I will be working with in a few weeks for Ron... I will be able to tell you more after I get started on the project ..

1915

General Mach Discussion / Re: set up

« on: December 01, 2006, 09:12:34 AM »

You need to set the steps per unit under the Motor Tuning. Or you can use the Calc steps per unit Calulator on the settings page...

1916

General Mach Discussion / Re: Slave A & X problems.

« on: December 01, 2006, 09:06:03 AM »

You need to have all the same settings for the A as the X axis. That should get you fixed

Thanks
Brian

1917

General Mach Discussion / Re: Slave A & X problems.

« on: November 29, 2006, 06:22:55 AM »

post the XML please

1918

Newfangled Solutions Mach3 Wizards / Re: cut rectangle wizard

« on: November 29, 2006, 12:12:13 AM »

It is on the list that I have going... I have to finish a few things that I am working on and I will spend a day just fixing little bugs. So if you see more please post them

Brian

1919

General Mach Discussion / Re: digitiseing

« on: November 29, 2006, 12:09:50 AM »

You need a cad/cam program that can take in a point cloud... it is not much fun

1920

General Mach Discussion / Re: Question on Probing and Mach3

« on: November 29, 2006, 12:07:46 AM »

Not at this time... What you are looking at can only be done with the teach wizard at this time.

Thanks
Brian