5891
General Mach Discussion / Re: Gear Reduction question.
« on: November 16, 2017, 12:36:24 PM »
Hi,
that project looks good. The equipment the back ground of your pic suggests that you are an avid builder.
Seems like a lot of gold to spend without being it will work. The advantage of the servo that Gerry mentioned is that it will hit its rated torque at 1500rpm,
no guessing involved.
Craig
that project looks good. The equipment the back ground of your pic suggests that you are an avid builder.
Quote
one more stepper driver along with the Screw jack mod and coupler I'm looking
roughly $700 extra dollars. Its a tough decision but I think this should do the trick.
Seems like a lot of gold to spend without being it will work. The advantage of the servo that Gerry mentioned is that it will hit its rated torque at 1500rpm,
no guessing involved.
Craig