Messages

291

Show"N"Tell ( Your Machines) / Re: Success! Mini Machining Center under Mach3 control - Video link

« on: May 05, 2009, 05:00:42 PM »

Hi, Simpson36

Very Nice job you've done, Show us more if you get time.

Chip

292

General Mach Discussion / Re: Problems threading on the lathe

« on: May 05, 2009, 12:28:02 AM »

I don't have 2 pp I can test with, don't know.

293

General Mach Discussion / Re: Problems threading on the lathe

« on: May 05, 2009, 12:16:18 AM »

Hi, Rich

If both are from the same, Examp. 10 you get this.

Give me a call.

Chip

294

General Mach Discussion / Re: Problems threading on the lathe

« on: May 04, 2009, 10:46:31 PM »

Hi, Rich

I think I've found the problem your having, You need to have both index & timing enabled with an active pulse stream or you'll get the high rpm indication.

The data scope doesn't have much pulse height if the Number of Slots is 1 ether.

Chip

295

General Mach Discussion / Re: Any one used xylotex boards to upgrade an EMCO lathe?

« on: May 04, 2009, 04:07:28 PM »

Hi, Jack

Hears an article I found on the web, Should make the conversion easier for you.

Chip

296

General Mach Discussion / Re: Problems threading on the lathe

« on: May 01, 2009, 09:08:42 PM »

Hi, Art

Thanks for the Info.

Now have Both Computers showing Scope Info.!!! 

The one with High "Last Index Rotation us" problem was being caused by having Mach3's Kernel Speed was set to "100K". 

Scope trace seems to only work up to 512 samples hear.

Have Fun on your Vacation, Chip 

297

General Mach Discussion / Re: Problems threading on the lathe

« on: May 01, 2009, 06:51:53 PM »

Hi, Art

The data scope isn't scaling the ms vertical to match the min/max stats value, I'll try the 1.03 plug in in a few minutes.

Chip

298

General Mach Discussion / Re: Problems threading on the lathe

« on: May 01, 2009, 02:12:24 PM »

Hi, Art

Hears a pic of the new plug in still no data displayed, I'll try it on my other computer later today.

Pin 10 is assigned to index, Trimming is on pin 11 simulated.

Chip

299

General Mach Discussion / Re: Problems threading on the lathe

« on: May 01, 2009, 01:24:32 PM »

Hi, Art

Getting very little to no output on scope hear with last 2 Data scope plug-ins.

Chip

300

LazyCam (Beta) / Re: LAZY CAM RAPID unit/min control

« on: April 29, 2009, 10:52:56 PM »

Hi, Ryan

Your rapids should be G0 moves, The only way to slow G0, G00  moves down is to set the "Velocity's" lower in Mach3's, Motor Tuning page for each axis.

All other moves are controlled by "F" settings associated with G01, G02 ....... type G code.

Chip