4791
Show"N"Tell ( Your Machines) / Re: DC-K40 Laser conversion issue
« on: May 22, 2014, 01:25:43 AM »
Hi Jeff,
Perhaps the GCode M11P1/M10P1 commands are the way forward - it is the system I now use.
This document and the attached comments refer http://hobbycncart.com/publ/cikkek/mach3_temaju_cikkek/switching_a_laser_under_mach_control/8-1-0-29
Hope this helps.
Tweakie.
Perhaps the GCode M11P1/M10P1 commands are the way forward - it is the system I now use.
This document and the attached comments refer http://hobbycncart.com/publ/cikkek/mach3_temaju_cikkek/switching_a_laser_under_mach_control/8-1-0-29
Hope this helps.
Tweakie.