1351
General Mach Discussion / Re: Port and Pin number for output
« on: August 14, 2019, 01:30:50 AM »
If you are using Port#1 for Mach3 then (from another of your posts) you need to set the Port#1 address to CFE8.
You also need to assign a Pin# for Output#1 (In Ports & Pins, Output Signals - the pin that is connected to your laser).
Tweakie.
You also need to assign a Pin# for Output#1 (In Ports & Pins, Output Signals - the pin that is connected to your laser).
Tweakie.