Good evening,
I use a jig with 8 locations to repeat 8 parts with 1 prog, the work offset table co-ordinates match the pitch of the actual jig.....simple.
The code just calls each fixture......still simple.
However, I have often asked myself if the table values could be locked. ( a tick box adjacent to each of the offsets).
Because. when I need to set zero of jig position 1 but inadvertantly have another fixture location (work offset) selected, when you zero each of the axis, this resets the values in the work offset table.
If I notice my error, I correct this by just entering the correct position again in the offset table, but its cought me out more than a few times and a few broken tools.
Its driver error but quite easy get wrong.
So maybe the reason for the offsets changing is when you zero but have the wrong offset selected
??
Mach is superb.
Derek