6781
General Mach Discussion / Re: Improving resolution on C axis
« on: November 26, 2012, 06:20:50 PM »
The thing is it is per degree that these units correlate to, not per mm or inch.
If you set it up as a linear axis then it would be 8000steps per unit and a unit would be 1 rev.
Presume however you would be wanting to use the rotational rollover and shortest route on G0? If so then you need it set as a rotary, you just have to set the rapid speed accordingly so that you get the RPM you want.
Hood
If you set it up as a linear axis then it would be 8000steps per unit and a unit would be 1 rev.
Presume however you would be wanting to use the rotational rollover and shortest route on G0? If so then you need it set as a rotary, you just have to set the rapid speed accordingly so that you get the RPM you want.
Hood