8441
General Mach Discussion / Re: wiring cnc control to ltp port??? how???
« on: February 03, 2010, 06:10:07 AM »
Hi Alex,
If you use a breakout board this enables a parallel LPT cable to be used from your PC. Then connect the breakout board pins to your CNC controller in accordance with the step and direction assignments you have set within Mach.
Tweakie.
If you use a breakout board this enables a parallel LPT cable to be used from your PC. Then connect the breakout board pins to your CNC controller in accordance with the step and direction assignments you have set within Mach.
Tweakie.