3251
Share Your GCode / Re: Bentley logo G codes help
« on: November 15, 2016, 04:22:23 AM »
Your .dxf file appears to be bad (corrupt) which is the reason you cannot open it in CamBam.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I am having exactly the same problem with windows xp computer... runs fine until Mach 3 runs... then screen blinks a couple times and it shuts down and turns off. Its worse with the cnc power supply turned on. Paid a tec guy to do the xp setup to follow the optimization sheet from the site here... no improvement. This issue of course completely stops any movement forward. will post this on individual post, but if someone reads this please reply
thanks bob