1
General Mach Discussion / Re: Where to input value to let X-Y table move certain distance directly?
« on: November 30, 2022, 11:48:58 AM »
easy use "jog cycle step" mode
fill increment move step.. then u just press where u go.. and viola..
ex: i need go axis x 6mm
i fill 2mm increment.. just press > x3 or increment 6mm just pres > once
i hope this can help
fill increment move step.. then u just press where u go.. and viola..
ex: i need go axis x 6mm
i fill 2mm increment.. just press > x3 or increment 6mm just pres > once
i hope this can help