8531
General Mach Discussion / Re: touch probe file converting to g gode??
« on: December 01, 2009, 05:19:52 AM »
Another excellent program Al.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I have the spindle output hooked up to a pneumatic air gun that dispenses glue. The glue is going to form the .060" diameter circle. the problem is the blasted spindle dwell. When the M3 is called out, the glue comes out for .5 seconds and then does the circle and then comes out another .5 seconds after the circle is done.