6961
General Mach Discussion / Re: Many lost steps in CV mode for A + Z movements
« on: October 28, 2008, 06:02:06 PM »
joshin,
Do a search "settiing up 4th axis" as i think you will find a lot of different posts in there which may be of interest to you.
One is about linear movement based on using diameter of a part. I usualy only use only degrees. Think you'll fiind some good
tips there.
RICH
Quote
Is there another set up for a rotary axis than angular rotation ? I only know angular rotation.
Do a search "settiing up 4th axis" as i think you will find a lot of different posts in there which may be of interest to you.
One is about linear movement based on using diameter of a part. I usualy only use only degrees. Think you'll fiind some good
tips there.
RICH